speed density

[rb evo]

just been looking a sd remaps are they better than a normal remap for evo 8 and why thanks

 

[supamario666]

just been looking a sd remaps are they better than a normal remap for evo 8 and why thanks

It remove's the rubbish MAF Mate for a start!

 

[RsvRob]

It reads air temp and pressure for better control of air fuel mixture.

 

[rb evo]

Is it much more to map this way I know u need a couple of sensors fitting but have seen a few kits that's quite cheep thanks

 

[And@fcm]

We do the same price cor sd and maf cars as its pretty much the same time
andy

 

[rb evo]

What's price for sd with sensors fitted drive in drive out cheerS

 

[And@fcm]

it depends on were we fit the temp sensor, do you have a hard pipe kit? as it can be mounted in the top pipe otherwise its a manifold off job to fit in on the manifold

Andy

 

[rb evo]

Yes I have a hard pipe kit cheers

 

[evobob]

I was told my e8 couldnt run a sd map as need a e9 inlet, loom & evo to run one? Im confussed?

 

[B6lee]

I was told my e8 couldnt run a sd map as need a e9 inlet, loom & evo to run one? Im confussed?

thats a load off rubbish.

yea using the 9 inlet isn't a bad idea with its sensors but theses sensors will obviously need to be wired in so a lot just tend to opt for fitting air temp sensor into a hardpipe

 

[evobob]

So what sensors are needed & what at cost?

 

[And@fcm]

Yeah its a lot of rubbish. My own 8 runs sd. Need a air temp sensor and map sensor. Wire then in and fit and good to go. The 9 manifold already has the holes for the sensors that's why is easier to fit one. I can get prices for you both

andy

 

[evobob]

Were would they wire to? (The standard maf plug?) Also dont think itd hurt putting a price up as think itd be handy for the people out there. Also have seen people run a blow through maf which uses the standard maf sensor just put in a hard pipe after the intercooler, is that prety much whats needed here?

 

[rb evo]

Thanks Andy

 

[And@fcm]

the map sensor wires direct to the ecu and the temp sensor wires to the MAF plug. Once on SD you can remove the MAF and put in a large pipe to feed the turbo

Andy

 

[And@fcm]

Ok for the complete drive in and out with sensors etc, is £590 for fitting in the top hard pipe and £740 for manifold fitment. Prices include VAT and we would need the car for 2days to make sure all is well (and welding the appropriate part) etc.

We also perform a compression test and full boost leak test and general health check on all cars before we map them.

Cheers
Andy

 

[Smokey]

Andy, what sensors are needed and is it a big job to fit them?
I have my engine out ATM so could fit them.

 

[And@fcm]

just a temperature sensor and map sensor, not really a big job just need to weld on some mounts for them