Kelford 272 cams evo 9

[bakes fq]

What sort of bhp and ft torque should I see from fitting these cams to my 9 ...? Performance mods so far are 3 port, fuel pump,decat, and hks filter ... Cheers

 

[Simon@NTS]

I would say there too aggressive for your setup.

 

[bakes fq]

I would say there too aggressive for your setup.

What would u recommend m8 for more power ?

 

[And@fcm]

These are good cams but you have to change the spring s and retainers as well, good for top end power. Is recommend the keyword 264's great mid range torque and power

 

[bakes fq]

These are good cams but you have to change the spring s and retainers as well, good for top end power. Is recommend the keyword 264's great mid range torque and power

Roughly what sort of bhp / torque am I looking at fitting these m8?

 

[And@fcm]

i'm assuming that you've already had a remap? with those mods you've qall ready mentioned are you running about 410-420bhp and similar torque? the cams cams would probably see 20bhp 20lbft in the mid range (may be a bit more) but for the cost (as you'd have to pay for an adjustable cam pulley, fitting and remapping its probably not worth it as you'd be on the limits of the bottom end

Andy

 

[Simon@NTS]

These are good cams but you have to change the spring s and retainers as well, good for top end power. Is recommend the keyword 264's great mid range torque and power

+1

 

[And@fcm]

These are good cams but you have to change the spring s and retainers as well, good for top end power. Is recommend the keyword 264's great mid range torque and power

hehe just noticed a few spelling mistakes in this, its cause I sent it from my phone with predictive on. should have read

I'd recommend the kelford 264's great mid range torque and power

 

[bakes fq]

i'm assuming that you've already had a remap? with those mods you've qall ready mentioned are you running about 410-420bhp and similar torque? the cams cams would probably see 20bhp 20lbft in the mid range (may be a bit more) but for the cost (as you'd have to pay for an adjustable cam pulley, fitting and remapping its probably not worth it as you'd be on the limits of the bottom end

Andy

Yes m8 i got it mapped on the rd and I see what u mean : ( . So if I get it on the rollers and I'm not hitting The 400 mark , would it be safe to fit the cams and then get it mapped again ?

 

[And@fcm]

potentially, what boost are you running now and who mapped it for you? would be worth speaking to them also

Andy

 

[bakes fq]

potentially, what boost are you running now and who mapped it for you? would be worth speaking to them also

Rich at Rg Motersport mapped it , mite have to give him alittle call and see what he says as I can't remember the full boost I'm
Running at the mo : ( . That's for the advice : )