L
Little Ends
New Member
- Messages
- 2
Hi guys.
I don't own an Evo, but have a Fiat Coupe 2.0 20V turbo.
I need some thoughts as I know a lot of people run PTE6262's on their Evo's. In the states at least.
My setup is the following(the important bits).
PTE6262 DBB with .82AR turbine housing
PTE 46mm external wastegate
Full 3.5" exhaust from turbo
Fully forged engine
I made 502WHP when my car was mapped, running 2bar at 7850rpm. My car revs to 8250rpm, but I had maxxed the dyno out as it was limited to 145mph, and my car does 160mph in 4th gear, which is what the run was done in.
Here is my question. Does 502WHP at 2bar seem like an accurate power figure on a 6262? I see guys on here running 600WHP and over with the same sort of setup.
I've had doubts about whether the mapper extracted everything out of the setup, although it is running very safe. If I take my car up against a car with the same setup but with a GTX3071R, I am only just pulling away from him, which doesn't seem right to me!
I don't own an Evo, but have a Fiat Coupe 2.0 20V turbo.
I need some thoughts as I know a lot of people run PTE6262's on their Evo's. In the states at least.
My setup is the following(the important bits).
PTE6262 DBB with .82AR turbine housing
PTE 46mm external wastegate
Full 3.5" exhaust from turbo
Fully forged engine
I made 502WHP when my car was mapped, running 2bar at 7850rpm. My car revs to 8250rpm, but I had maxxed the dyno out as it was limited to 145mph, and my car does 160mph in 4th gear, which is what the run was done in.
Here is my question. Does 502WHP at 2bar seem like an accurate power figure on a 6262? I see guys on here running 600WHP and over with the same sort of setup.
I've had doubts about whether the mapper extracted everything out of the setup, although it is running very safe. If I take my car up against a car with the same setup but with a GTX3071R, I am only just pulling away from him, which doesn't seem right to me!