torque settings..

[Befni]

does ANYONE know the torque settings for evo 4 drive shaft hub nut's at all or know a website i can get them from please lol x I'm actually desperate x

 

[evo arm's m7960]

hi befni in the manual it seams to say tighten between 177nm to 275nm hope that helps for the front

 

[youngy_315]

that sounds right.... i thought it was 225 + or - 25 nm so its the same

 

[evo arm's m7960]

from the manual

If the limit value of hub axial play cannot be obtained
with the nut tightened to the specified torque (177 to
275 Nm {18.0 to 28.0 kgf
m}), replace the front hub

Before securely tightening the drive shaft nuts, make
sure there is no load on the wheel bearings.
(3) If the position of the split pin holes does not match, tighten
the nut up to the first matching holes.
Install the split pin and bend it securely.


:O)

 

[evo arm's m7960]

the rear is


If the specified torquing range (196 to 255 Nm {20.0
to 26.0 kgf
m}) does not bring the wheel bearing axial
play into the limit, replace the rear hub assembly

:O)

 

[Befni]

thank you lad's much appreciated. If all goes well evo back on road tomorrow after a long month of it bein on my drive lol. Wheels re sprayed everythin gettin done atm little bits to get it lookin reem! X