Re map

[Smokey]

Who can map my 7 i have the Ecu-tek license. is the ecu-tek remap better?
I know it comes down to the mapper.
I am based in the sw. open to suggestions.

 

[B6lee]

get youself over to indigo-gt mate. antony knows his stuff

 

[And@fcm]

we can do this for you and we're based in bristol we also have an offer on at the moment for a full remap for £200 which includes before and after road dyno results, boost leak test and compression test

andy

 

[Smokey]

we can do this for you and we're based in bristol we also have an offer on at the moment for a full remap for £200 which includes before and after road dyno results, boost leak test and compression test

andy

Do you use the ecu-tek software?

 

[And@fcm]

no but we leave your license in place,

 

[Smokey]

The car has been mapped before by powerstation, are they any good? a few people said that they aren't great.

What sort of power/torque should i see from a remap+ stage 1 mods?

How longs the offer on for?

 

[And@fcm]

our offer is on till end of Jan, for stage one mods then your looking at around 360-380 depending on the supporting mods.

Andy

 

[Ozy]

Abdy I got 385bhp from my mrfq300shud I of got more got the usual fuel pump 3inch turbo back miltek, turbosmart dumpl valve and avcr boost controller bout a year ago

 

[And@fcm]

thats sounds about right for a 9.8 turbo if you have the 10.5 turbo then you could expect nearer the 400 mark, although depends on boost too. What boost are you running
Andy

 

[Ozy]

1.6 sumtimes read 1.7

 

[Smokey]

our offer is on till end of Jan, for stage one mods then your looking at around 360-380 depending on the supporting mods.

Andy

Andy do you do the mapping for fcm? I have been looking through paper work i got with the car (only had the car 4 days) and it says i have a re con turbo from turbo dynamics part number 49578-1580 would this be the evo 9 turbo? I also got a power graph from powerstation. i Will try and put it up so you can look at it.

 

[And@fcm]

yeah i do the mapping, the number looks like an 80 series, you could run about 1.8 bar if you wanted a little bit more power