Interior trim parts removal.

[Leigh_EvoIX]

Haven't really looked yet and I'm sure its not difficult, just looking for a few pointers.

I'm having my window switch surrounds wrapped in carbon vinyl.

So how do they come out from the arm rest on the door? Blunt knife under the edge and lever them up or are they screwed in any way?

Also the passenger side "A" pillar is creaking like a good un... how does this come off so I can try to sort it? Just get my fingers behind and give a tug to pop the clips off?

 

[B6lee]

Have a look in the hole where you put fingers to close door and you'll see a screw then just pull them out

Yea A pillar trim just clipped on

 

[fq-craigus]

The window switch panel is just clipped in and there is 3 or 4 screws on the underside to remove the switches from the panel. Yh summat blunt will get it out, the handle/ pocket has a screw to remove and just pops out too

 

[Leigh_EvoIX]

Right then front switches and double din surround are out. Can't get the rears out though. Managed to get one up but the clips broke and the switch unit seems to be hard to get out when it's attached to the switch surround.

Surely the door card doesn't need to come off.

 

[rich_f]

Surely the door card doesn't need to come off.

If I remember right I had to take the door cards out to get the switch surrounds out

 

[Leigh_EvoIX]

what, for the rears?

 

[rich_f]

what, for the rears?

Yer for the rears

 

[rich_f]

U could just leaver them out but you may snap the lugs

 

[Leigh_EvoIX]

Ah ok... Odd that the rears need door card removal and the fronts just pop out with a bit of persuasion. Who do the rear door cards come off then?

 

[B6lee]

Undo 3 screws then fingers behind bottom of panel and pull/pop it off

 

[rich_f]

Undo 3 screws then fingers behind bottom of panel and pull/pop it off

Just like that lol

 

[fq-craigus]

they will just pop out mateonce up a lil use ur fingers to push the lugs inwards preventing them snapping