Help and advice installing a Defi Boost and Oil pressure gauge in an Evo VI

[B6lee]

No need to chop it, just put the T piece at one end and another bit of pipe the same size to connect it back up.

You can use any of the vac pipes on the inlet manifold just advisable not to use the fuel pressure reg one

Check my post history mate and you'll see I now what I'm talking about. Been fiddling with evos for almost 3 years now

 

[markyd3]

No need to chop it, just put the T piece at one end and another bit of pipe the same size to connect it back up.

You can use any of the vac pipes on the inlet manifold just advisable not to use the fuel pressure reg one

Check my post history mate and you'll see I now what I'm talking about. Been fiddling with evos for almost 3 years now

Hello mate, lol it wasnt that i didnt trust you.. Its just i wanted to be totally sure i was cutting the correct hose.... but as you say i dont actually need to cut it.... i didnt think of that!!! lol

Cheers,

Mark

 

[markyd3]

could someone just tell me if this is the right adaptor i need to install the oil pressure sender?

Oil and Water Gauge Adapter 3/8 NPT to 1/8 NPT (069) on eBay (end time 14-Jun-11 22:54:39 BST)

 

[B6lee]

Hello mate, lol it wasnt that i didnt trust you.. Its just i wanted to be totally sure i was cutting the correct hose.... but as you say i dont actually need to cut it.... i didnt think of that!!! lol

Cheers,

Mark

No worries

 

[fq-craigus]

Think ill wait until next oil change as its fresh inside at the moment