evo cut out.

P

popcorn84

New Member
Messages
19
i have a mitsubishi evo 4 imported from japan and having a little problem,it seems that when ever i put my foot flat down and then release my power completely go's and the car dies it does normally come back on when i have turned the ignition but not sure what the problem is.can anyone tell me why this is and what i need to fix?
thank you
 
fq-craigus

fq-craigus

Well-Known Member
Messages
8,136
Location
Boston
Do you have a dump valve on??? A load of people just put them on without a map but the Evo doesn like them
 
Phil74

Phil74

Trader
Trader
Do you have an evoscan or muc II scan tool? Do you know how to bridge the wires to see if any fault codes come up?

join pins one and four with a piece of wire, pin one is top left , pin four is to the right fourth on top as you look at your pic .long flashes are tens and short flashes are units, steady flashes no error codes. To reset the ECU afterwards, just disconnect the battery for 10 seconds.

Could be in the ecu or a sensor or bov
 
P

popcorn84

New Member
Messages
19
no it does not have a dump valve?any other ideas??
 
RsvRob

RsvRob

Well-Known Member
Messages
2,882
Location
Beds
No dv may be your problem...
Any boost leaks?
Has the battery been disconnected?
What do you meen by power goes, is this while driving or stationary?
 
P

popcorn84

New Member
Messages
19
the power cuts out whilst im driving and i dont think its boosting properly im looking at changing my turbo actuator,will this help the boost?
 
Top