Evo 5 ceddy rom/def

Danny_lad

Danny_lad

Member
Messages
66
Location
Manchester
Currently got the ceddy rom for the evo 5 all up and working !
It's all currently setup of Todd, which a massive thanks is due!

but we've kept the Gizzmo to 1.0bar currently as I'm still on stand fuel pump and airbox still till next week.

What boost can the evo 5 fuel pump take? Out of interest! But I will upload my maps and logs ASAP for you ! as I'm new to the evo side, but I've been using romraider on the scoob for a while.
 
Danny_lad

Danny_lad

Member
Messages
66
Location
Manchester
What's everyone using for the sas setting for pops and bangs? I've got a vta and it seem to just bang the once not crackle or pop on over run?

Any ideas?

These are the ones I've copied,

On my five

min trig speed 24
min trig RPM 3000
min trig load
min trig coolant 50
min trig time 2.0
valid trig time 2.0
load below which active 45%
Active time limit 12
Delay before air injection 0.1
delay before fuel injection 0.1
Fuel Injection time 4.8
Air in jection time

2000 0.7
2500 1.2
3000 1.6
3500 - 5500 1.9
6000 1.5
 
RsvRob

RsvRob

Well-Known Member
Messages
2,882
Location
Beds
Vta will cause 1 bang.
Recirc will give machine gun effect.
Helps to drill sas bolts out to 5-6mm aswell.
Mess around with air injection times for different effects....
Also because you have set -20 doesn't meen you'll get that unless you have altered the table to allow that much. Or you'll still only see -10. You can try logging to see if you get -20!!
 
Last edited:
Danny_lad

Danny_lad

Member
Messages
66
Location
Manchester
Thanks mate,

I've drilled my sas bolts out to 6mm and I've used this setting of another member, the car came with a ssqv and I'm looking at going back to a flutter!

So if I remove the dv and blank it off will I get the same effect?bovs aren't all for me
 
RsvRob

RsvRob

Well-Known Member
Messages
2,882
Location
Beds
No bov will be one bang and possibly cause stalling
 
Danny_lad

Danny_lad

Member
Messages
66
Location
Manchester
Yeah been chatting to Todd, I need to check a my sas piping is a correct and make sure the solnoid isn't full of carbon also
 
Danny_lad

Danny_lad

Member
Messages
66
Location
Manchester
I'm going to change to recirc but also read up that you can turn my hks ssqv in to a 100% recirc and mines a real one too!

I suppose that will work won't it?
 
Top