boost gauge install

[liverpool1]

hi can some one tell me how to get the plastic pipe though the head of the engine bay can not find any holes ? any pics please or info thanks ted

 

[liverpool1]

boost pipe

any one got any thoughts how to get the pastic pipe of the boost gauge to the inside of the car from the engine bay there does not seem to be any holes to feed it though cheers

 

[rich_f]

go through 1 of the rubber gromits in the bay i have run mine in through the drivers side and in to thr A piller will go take a pic and post it up later.

 

[liverpool1]

cheers for that your a star

 

[rich_f]

right this is bit of a pig to get to but u should ok

as u stand in front of the bay the very far top left corner your find a cut out that goes in to the car (see pic)

push through as much tube as u can

then remove part of the lower dash under steering wheel

then try and look up the back of the dash from your pedals

you should see it curling up just above the fuse box


hope this helps

any problems let me know

rich

 

[rich_f]

had a look and all i could find was a few locations where wireing looms pass through in to the car so you bets bet is to look 4 one of thers see attached pics.

yellow circles show the gromits.

good luck
hope it helps


rich