dannylancer
New Member
- Messages
- 77
- Location
- Hartlepool
engine management light came on again this mornin, fault code was P0505, some kind of idle control fault, can anyone shed any light on this for me,what could it be
R
roachy
New Member
- Messages
- 1
- Location
- codsall staffs
hi,got mine back today from mitsi dealer in stoke,idle speed control problem, its the stepper motor,tricky, has to be adjusted and will keep throwing light up but will cause no lasting damage they told me
Danii
New Member
- Messages
- 20
- Location
- Scottish Borders
I am also having ecu light issues & it keeps comming up with idle speed control.
the Mitsi dealer told me it would need a whole new throttle body :s
the Mitsi dealer told me it would need a whole new throttle body :s
ElDopesta
Well-Known Member
- Messages
- 5,705
- Location
- Nuneaton
Stepper problem indeed.
If you take it to the dealers i believe they will charge a fee of £400+ which is ridiculous because most of the time they would rather change the stepper then faf about tweaking it!
Tricky indeed for those bafoons!
Best bet is to disconnect the battery, take the stepper off and clean it thoroughly but try not to mess with the screws. put it back on, re connect the battery and see how it is, if there is no joy then at least it is clean and then what you want to do is take the evo to your nearest tuner and get them to tweak the controller to idle at 1100 or so and then bring it back down to base. A hell of a lot less cost and maybe a cheap dyno run too?????
If you want to have ago at it yourself then i will be happy to give you further detailed instructions.
Good luck buddy and please let us know how you got on.
If you take it to the dealers i believe they will charge a fee of £400+ which is ridiculous because most of the time they would rather change the stepper then faf about tweaking it!
Tricky indeed for those bafoons!
Best bet is to disconnect the battery, take the stepper off and clean it thoroughly but try not to mess with the screws. put it back on, re connect the battery and see how it is, if there is no joy then at least it is clean and then what you want to do is take the evo to your nearest tuner and get them to tweak the controller to idle at 1100 or so and then bring it back down to base. A hell of a lot less cost and maybe a cheap dyno run too?????
If you want to have ago at it yourself then i will be happy to give you further detailed instructions.
Good luck buddy and please let us know how you got on.
dannylancer
New Member
- Messages
- 77
- Location
- Hartlepool
thanks for your advice mate, the car is back at the garage i bought it from so there sorting it out, they didnt want to know about my problems until i gave there head office a quick phone call. will let you know what they have done cheers
R
Rijolad80
New Member
- Messages
- 1
engine management light came on this mornin, fault code was P0505, some kind of idle control fault, can anyone shed any light on this for me,what could it be thanks Ryan
Ev0Bee
New Member
- Messages
- 12
Hi,
P0505 usually requires a base idle reset via evo scan or similar. 260s are renowned for this issue. If the light comes back on as ElDopesta said... remove the idler stepper motor clean everything(body and motor cone head).
Do either of these cars stall on low speed manoeuvring with the air con on.
Are either of them cam'd
Scott
P0505 usually requires a base idle reset via evo scan or similar. 260s are renowned for this issue. If the light comes back on as ElDopesta said... remove the idler stepper motor clean everything(body and motor cone head).
Do either of these cars stall on low speed manoeuvring with the air con on.
Are either of them cam'd
Scott