Ali welder in northampton to modify Subaru inlet

[kj200sx]

Hi basically have Subaru that I took of a mate and has had a new engine fitted but a later one and the heads are slightly different meaning the inlet manifold won't fit I have 3 manifolds it total the correct one for the engine fitted but wiring is different and 2 for the previous ver 3 type engine so am basically looking for someone to cut them about slightly and get it to fit as the car obviously worth a lot more if it's on the road and a shame to break it as is a limited edition and quite a tidy car overall as close to northampton as possible really thanks people

 

[towcestervag]

theres a alloy welder next to cgr car sales in towcester

 

[RsvRob]

Would it not be easier to alter the wiring instead?!?!

 

[kj200sx]

I have looked everywhere for info on this and can't find any have you done this befor? Apparently it's the ic valve that's different mainly but as I say struggling to get any definate answers

 

[RsvRob]

You should only need a wiring diagram for both types.
Then away you go!!!

 

[kj200sx]

Bit beyond me I think tbh and don't want to make things worse just a shame to break the car for that as not bad overall and is a limited edition so would be good if up and running there are more wires on the later ic I think but may have a look and see might not be to hard