abs and ayc lights

[jimbo]

hi, my abs and ayc lights are both on , on my evo iv , looking for any sugestions of what to start looking for , i have been thinking possibly just one of the sensors are faulty , as i'm led to believe one sensor does both ? is there any way of testing the sensors?

 

[jamie@evotune]

First thing to do is read the flash codes bridge pins 1&4 out of the obd connector and read the flash codes on the dash displayed by the abs/ayc lights long flashes are 10's short flahes are 1's so 2 long flashes followed by 3 short flashes would be 23

 

[B6lee]

First thing to do is read the flash codes bridge pins 1&4 out of the obd connector and read the flash codes on the dash displayed by the abs/ayc lights long flashes are 10's short flahes are 1's so 2 long flashes followed by 3 short flashes would be 23

Good call !!

 

[jimbo]

thanks again for your help this is most appreciated , where do i find the obd connector , is this the one under the steering wheel , and the codes would apply to those in the service manual i downloaded ?

 

[jamie@evotune]

thanks again for your help this is most appreciated , where do i find the obd connector , is this the one under the steering wheel , and the codes would apply to those in the service manual i downloaded ?

OBD is just under the o/s/f kick panel inline with the clutch pedal post up the codes you find

 

[jimbo]

ok , i'll get this done tomorrow too , and again i cant thank you enough for the advice , there is alot more to these engines than my previous cars .

 

[jamie@evotune]

:blush:

ok , i'll get this done tomorrow too , and again i cant thank you enough for the advice , there is alot more to these engines than my previous cars .

It not a problem were here to help

 

[jimbo]

good to find a site with helpful interested people

 

[jimbo]

would you have a pic of which end and row no 1 is , or where i could find a diagram , i dont wont to end up shorting something , or able to describe possibly with reference to plug locator ?

 

[B6lee]

If you look very closely you'll see the numbers next to the pins

Just poke one end of wire in hole number 1 and the other in hole number 4 and turn the ignition

 

[jimbo]

did look closely and couldnt see any numbers but i could be wrong , i am looking at the plug above the clutch pedal just where my plastic trim ends under the steering wheel , am i at the correct plug ?

 

[sponners]

pic.......to the rescue

 

[jimbo]

thanks a lot , i'll get out and check this the morrow as it's pitch black and my work lamps playin up , i'll post my results tomorrow

 

[ElDopesta]

First thing to do is read the flash codes bridge pins 1&4 out of the obd connector and read the flash codes on the dash displayed by the abs/ayc lights long flashes are 10's short flahes are 1's so 2 long flashes followed by 3 short flashes would be 23

Well done Jamie, on the ball as usual I see!

pic.......to the rescue

Nice one Mark, if you made the pic posts a regular thing, this would be the best place in the world for Tech issues!!!


El