Carbon Evo 1-6 Parts, Enjoy!!!

[FAZ@CarbonFinish]

I was looking at r-spec heat shield but dont like the s/s. Is there much difference in price for matt black and carbon finish on the vortex generator? Primer i get but still its £110 plus postage and then have to pay to get it painted...rather have it ready to fit when i get it. Sure yours dont have to bonded on? Can you get me a price on an E5 rear bumper exhaust heat shield but if its to much hassle for you getting just 1 of them i will source that elsewhere. Thanks

Hi mate, the matt black version will most likely be cheaper but cant get any final prices until tomorrow.

In regards to fitting the EVO 7-9 VG need tiger seal or 3m tape , when either one is applied the fitting is flush to the roof ie no gaps so no room for air to get in. ( I have this on my own car )

For the evo 4-6 Vortex Generator we have only sold these overseas and have not had any issues back about fitting etc, but will most likely still need tiger seal or 3m to fit on

Ill find out for you about all your parts by tuesday mate

 

[Phil74]

Thanks and thats appreciated, I would like a black vortex generator as my evo is pyreness pearl black. Would like the exhaust heat shield also in black if possible but if not then carbon if fine. The other vortex generators i have seen have to be bonded on with tiger seal also and think i would prefer that over 3m tape.

 

[FAZ@CarbonFinish]

Thanks and thats appreciated, I would like a black vortex generator as my evo is pyreness pearl black. Would like the exhaust heat shield also in black if possible but if not then carbon if fine. The other vortex generators i have seen have to be bonded on with tiger seal also and think i would prefer that over 3m tape.

Tiger seal is much better mate, seriously Ive heard of VG's flying off mix of spped and quality, ive done 180 and nothing, this was literally the day after i installed it.

 

[Phil74]

Any joy with the vortex generator in black for E5???? What about heat shield for exhaust on rear bumper?

 

[FAZ@CarbonFinish]

PM sent mate

 

[Phil74]

Nice one Received. Thnaks