My Evo 4 Project Forged from Lpool

toqeer1986

toqeer1986

Member
Messages
122
:twisted:

bought without an engine poor thing mistreated, good job I got hold of it to restore its life,

Evo 5 Block + Head

JE 86mm Stroker Pistons

Crower Crank 100mm

Williams Conrod

ACL Race Bearings + Thrust

more to come ........





 
toqeer1986

toqeer1986

Member
Messages
122
btw whats that shrink wrapped chip ??? speedo converter ?
 
martinthegooner

martinthegooner

Well-Known Member
Messages
2,177
Location
Maidstone,Kent
nice to see another 4 being saved and not broken for parts
 
Last edited:
toqeer1986

toqeer1986

Member
Messages
122
complete chassis is clean I couldn't break the poor thing just like the glanza v when I bought it with a hole in the block size of a 5 inch burger lol
 
Y

yates

New Member
Messages
301
good luck with this mate, least you can get that engine bay all spic and span!
 
Tom2741

Tom2741

Active Member
Messages
748
Location
Norfolk
Looks like you've got some good plans for it. Is what a repair on a crack in the block?
 
toqeer1986

toqeer1986

Member
Messages
122
seems like quik steel put on think its a crack will get it x-rayed and find out if cast welding it will hold
 
RsvRob

RsvRob

Well-Known Member
Messages
2,882
Location
Beds
Why the crower crank?
If the shrink wraped sensor came of the gearbox then yes its the speed sensor...

And if the block is cracked then I'd personally say its scrap. Get internals checked as other damage may have been done...
 
B6lee

B6lee

Community Leader
Messages
13,370
Location
Bath
Why the crower crank?
If the shrink wraped sensor came of the gearbox then yes its the speed sensor...

And if the block is cracked then I'd personally say its scrap. Get internals checked as other damage may have been done...

+1
 
toqeer1986

toqeer1986

Member
Messages
122
block going to be checked inspected no other damage just that crack, crank crower because I got it cheaper than stock lol :D
 
toqeer1986

toqeer1986

Member
Messages
122
plus its stroker crank that's the route ive taken with stroker pistons and rods
 
Top