HOW TO: Throttle shaft seal

[Simon@NTS]

19. Install the new seals with a 12mm socket

 

[Simon@NTS]

20. With the seals installed, you can re-assemble, remember to grease the seals and shaft bearings

 

[Simon@NTS]

21. On re-assembly don't forget to thread lock the butterfly screws in

 

[Simon@NTS]

23. You probably need to replace the ICV bolts with something like this

 

[Simon@NTS]

24. Assemble in reverse order, you may need to setup the idle

 

[supamario666]

Cracking Thread Simon! Thanks for taking the time out to do this!

 

[Simon@NTS]

No probs James

 

[evo arm's m7960]

great write up :0)


.

 

[Simon@NTS]

Thanks some of the pics aint so great but you get the general idea

 

[redevo]

Where did you get the seals from and how much?

 

[supamario666]

Thanks some of the pics aint so great but you get the general idea

Anything to do with the can of Export Spud!!!

 

[Simon@NTS]

Where did you get the seals from and how much?

Think their about £25, there not cheap

 

[Simon@NTS]

Anything to do with the can of Export Spud!!!

Of course Meat

 

[mart1983]

sweeeet...

 

[mart1983]

just done this.. if you have a short temper like me dont do it...

 

[supamario666]

just done this.. if you have a short temper like me dont do it...

HAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHAHA!!!:whistling: Why doesn't that surprise me!!!:angel:

 

[mart1983]

Looks nice tho.. Lol

 

[mart1983]

i would say one thing to look out for is the butterfly! due to wear and tear you have to make sure it goes back in the same way it come out! i put mine upside down and it was all out..nothing lined up..... lol