Cam timing

[Steevo]

Hello can somebody tell me where the bottom pulley lines up for cam belt tensioning please

 

[ElDopesta]

Ring the number that I just Texted to you buddy.

I am just in the middle of a long thing so don't worry about the job your doing right now. He will look after you.

My Shudoshi will deal with it for you.

El

 

[Steevo]

I havnt had any numbers dude

 

[ElDopesta]

The crank and cams are all marked, you will need a diagram as it is not a cup of tea.
I just rang my Shudoshi and he says the same thing.

I think that Russ might have something that he can put on the table buddy.
After seeing his manual spec sheet for the rear spoiler brackets, I would be very surprised if he did not have it!!!

Give him a shout buddy.

El

 

[ElDopesta]

Did you not just text me a while ago asking if your mechanic can ring me???

 

[ElDopesta]

PM is being sent right now.

 

[sponners]

pretty straight forward job mate, just watch out for the balance shaft sprocket when doing this belt as it can be 360 degrees out (yes I meant to say 360 lol)

 

[ElDopesta]

There is no balance shaft sprocket on Steevo's engine.

El

 

[Cossie1]

I sent him the relevant page from the workshop manual, so hopefully he will be ok now.

 

[ElDopesta]

Thanks Russ. I knew you would have it to hand

My memory stick is corrupted and the other Autodata software I have is on my work PC at the Garage.

Nice one buddy.

El

 

[Cossie1]

No probs